importjae.blogg.se

1. #Polycom configuration file generator tool software#
2. #Polycom configuration file generator tool plus#
3. #Polycom configuration file generator tool download#

The order of files listed in it *is* important, as parameters in previous files override the parameters in later files.įor the example we will use 000411223344 as the MAC address. We have two lines, extension 1000 which is Line 1 (private) and extension 2000 which is Line 2 (shared for SLA).Ĭontains pointers to other files.

#Polycom configuration file generator tool plus#

Here we do the same as above plus some addition configuration. Register two SIP User Agents, one using Shared Line Appearance (SLA) We set the NTP server, time to EST, enable presence, set voicemail call back to *1, and fill in the authentication credentials needed. This was tested on firmware 4.0.3 but I've also tested it on 3.X firmwares and should work fine. In this file, we can override ALL of the previously loaded variables. By default the phone will look for a file called 000411223344-phone.cfg For this example, we will use 000411223344 as our phone's MAC address. For this method, you will not need to modify any default configuration files because this file will contain the entire phone's configuration. I've found this to be the simplest method for provisioning a Polycom. For example, if we say mac.cfg, and the mac address is 000411223344 then the file name is: 000411223344.cfg MAC-phone.cfg Example phone specific filesĮach phone has three specific configuration files which are named accoring to its MAC address. If not, you might have problems with one way audio during directed call pikcup (intercept application). For more lines replace 1 & 2 with higher numbers. Instead, create local-sip.cfg and local-phones1.cfg (see bellow). If you want to change values do not change this files. The default configuration is splitted across sip.cfg and phones1.cfg. The split package has smaller application files, one for each model, and it allows for a faster boot.

Polycom has a recommended procedure for this, but I am using a simpler method: Each version has a subdirectory on my tftp server and the DHCP directs the phone to the specific subdirectory.

#Polycom configuration file generator tool software#

Some phones are end of support and need older software package.

#Polycom configuration file generator tool download#

Obtain Software and Configuration Files From PolycomĪll versions (except the latest one) are available on Polycom's site under the "sip download matrix" at:

As long as you did not provisioned your phone via the configuration files you can provision it via the WEB however, the WEB configuration options are quite limited.